-
-
Inspect vacuum plenum filter and clean as necessary. Refer to user manual for filter location and cleaning procedure.
-
Keep framework and conveyor belts clean of dirt build-up, grease, and oil residues.
-
Check side-drive belts for wear.
-
Check for worn or broken electrical connections.
-
Check plenum support (footpad) and that all casters (if equipped) are properly adjusted and in the locked position when operating.
-
-
-
Check drive belts for proper Belt Tension and Belt Tracking. Refer to the User manual. Note: Correct tension and tracking will prolong belt and drive bearing life.
-
Lubricate Uni-Drive Side Belt drive chain and width adjustment roller chain. Machines are shipped from the factory lubricated with food-grade grease (JAX – Magna-Plate 44-2 from Pressure Lube Inc.)
-
Cycle height and width adjustments and check for binding.
-
Inspect electric motors and gearbox for evidence of oil leakage, noise or vibration and keep unit free of dirt; excess accumulation of dirt or grease will affect the proper cooling of the units.
-
-
-
Remove drive belts. Drive and Idle Pulleys should be inspected for bearing wear and pulley damage. Remove any dirt build-up before drive belts are re-installed. Refer to User manual.
-
Check tension of the Uni-Drive Side Belt chain drive. Note: Proper tension is achieved when the horizontal sag in the chain measures between 1/8” and ¼” with drive belts in a fully opened position.
-
BEL 450/450X - Check arch cross member height adjustment slides for wear. Excessive wear may affect taping performance. Refer to User manual.
-
Clean vacuum plenum and fan. Refer to the User manual.
-
Check and lubricate swivel casters if equipped.
-
Check Vacuum Plenum and Case Taper for any loose or missing fasteners.
-
Run Plenum Vacuum Fan. Listen and check for unusual noises or excess vibration.
-
